ā 31 ā
9. Disconnect the 3 wire harnesses and ground
wire that connect the induction module to the
range wiring.
6. Lift the front of the cooktop frame.
7. Disconnect the bridge board wire harness.
10. Lift the cooktop assembly and place it on a
protective surface.
To remove the cooktop assembly on PS978:
1. See To remove the cooktop assembly on
PHS925: Follow steps 1 thru 6.
2. Lower and slide the cooktop assembly forward
to access and remove the wire entry shield.
Disconnect
5. Remove the four 1/4-in. hex-head screws (2 on
each side) that attach the front of the cooktop
frame to the range.
3. Pull the cooktop wiring thru the wire entry and
disconnect the 2 wire harnesses that connect
the cooktop assembly to the range.
8. Lower and slide the cooktop assembly forward
to access cooktop wiring.
Wire Entry Shield
4. Lift the cooktop assembly and place it on a
protective surface.
To Next Page
Loading...
