– 52 –
Smoke Eliminator/Vent Tube
The oven is equipped with a smoke eliminator and
an oven vent tube. The smoke eliminator and vent
tube are located near the right, rear, top corner of
the oven cavity. Air vented from the oven cavity will
pass through the catalyst and then enter the vent
tube to be exhausted from the vent located at the
vent trim.
To remove the smoke eliminator and oven vent
tube on PHS925:
1. Remove the oven door. (See Oven Door Assembly.)
2. Remove the two 1/4-in. hex-head screws and
the smoke eliminator from the ceiling of the
oven cavity.
Caution: To prevent damage to the control panel
and cooktop, care should be taken when positioning
the cooktop on top of the range body.
3. Lift the front of the cooktop panel (See Cooktop
Assembly, follow steps 1-6.), and place it on top
of the range as shown.
Smoke Eliminator
Note: Insulation is wrapped around and under the
vent tube.
6. Grasp the vent tube and its insulation and lift it
from the range.
Caution:
1. When installing the vent tube, make sure the
inside of the vent tube is free of insulation.
2. Upon reassembly, ensure displaced insulation
around the oven vent tube is returned to its
original position.
5. Remove the fi ve 1/4-in. hex-head screws (3 at the
rear and 2 on top) that attach the rear vent to the
range. Lift and remove the rear vent.
Rear Vent
4. Remove the two 1/4-in. hex-head screws that
attach the rear vent trim to the range. Lift and
remove the rear vent trim.
Rear Vent Trim
Vent Tube
(Continued next page)
To Next Page
Loading...
