15
Installation Instructions
LEVEL THE WASHER
Move the washer into final position.
• To check if the washer is level side to side,
open the lid and place a level at the back of
the opening above the dispenser drawer.
• To check if the washer is level front to back,
place a level at the side of the washer on the
edge where the cabinet side meets the top cover.
If the washer is not level, adjust the front leveling
legs. Turn clockwise to raise, counterclockwise to
lower.
7
SET REAR LEGS
Tilt the washer forward (pivot on front legs)
about 4 to 6 inches and gently lower the rear legs
back onto the floor. This action will set rear leg
adjustments to correspond to front settings.
6
Lower
Raise
To Next Page
Loading...
