Why is the LOCKED light on when I want to cook in my GE PT9050 Oven?
If the LOCKED light is on when you want to cook with your GE oven, the oven door is locked because the temperature inside the oven has not dropped below the locking temperature. Press the Cancel/Off pad and allow the oven to cool.
What to do if my GE PT9050 Oven door won't open after a clean cycle?
If the oven door of your GE oven will not open after a clean cycle, the oven is likely too hot. Allow the oven to cool below locking temperature.
Why is my GE PT9050 Oven not heating to the correct temperature?
The oven temperature may need adjustment. Consult the Special Features section for instructions on how to adjust the oven temperature.
Why is my GE PT9050 smoking excessively during the clean cycle?
Excessive smoke during the clean cycle is often due to excessive soil or grease. Press the Cancel/Off pad, open the windows to rid the room of smoke, wait until the LOCKED light goes off, wipe up the excess soil, and then reset the clean cycle.
How to stop excessive smoking during broiling in my GE PT9050?
If you experience excessive smoking during broiling, lower the rack position of the food to increase the distance from the burner element.
Why is my GE PT9050 Oven food not baking properly?
Several factors can affect baking. Ensure oven controls are properly set. Check that the rack position is correct and level. Use the correct cookware of the proper size. The oven temperature may need adjustment. Also, substituting ingredients can change the recipe outcome.
Why is my GE Oven food not broiling properly?
Make sure you select the appropriate broil mode. Note that convection crisp is not for broiling foods. Use the Cooking Guide for rack location suggestions. Ensure cookware is cool and suited for broiling. If using aluminum foil, conform to pan slits. In some areas the power (voltage) may be low, so preheat the broil element for 10 minutes.
Why does the "DOOR" flash in the display of my GE PT9050 Oven?
The message "DOOR" flashes in the display because the self-clean cycle has been selected but the door is not closed. Close the oven door and wait for it to finish locking. Also, "DOOR" will flash while the oven door is locking to start self-clean and steam clean, which is normal.
What to do if the "DOOR" light is on when I want to cook in my GE PT9050 Oven?
If the "DOOR" light is on when you want to cook, the oven door is locked because the temperature inside the oven has not dropped below the locking temperature. Press the Cancel/Off pad and allow the oven to cool.
Why does my new GE Oven smell like it's "burning"?
This is normal in a new oven and will disappear in time. To speed the process, set a self-clean cycle for a minimum of 3 hours. See the Cleaning the Oven section.
General| Brand | GE |
|---|---|
| Fuel Type | Electric |
| Wi-Fi Connect | Yes |
| Installation Type | Built-In |
| Precision Cooking System | Yes |
| Wi-Fi Enabled | Yes |
| Color | Stainless Steel |
| Oven Capacity | 5.0 cu. ft. |
| Self-Cleaning | Yes |
| Convection | Yes |
| Control Type | Touch |
| Width | 30 inches |
| Oven Cooking Modes | Bake, Convection Bake, Convection Roast, Broil, Warm |
To Next Page
