49-6000289 Rev. 0 13
INSTALLATION INSTRUCTIONS
3/8" WHITE TUBE
Connected from inlet three way ball valve to
reverse osmosis assembly
1. Connect one end of the 3/8" white tube to the inlet three
way ball valve.
2. Route the loose end of this tube to the white collet fitting
on the Reverse Osmosis assembly.
3. Cut tube square and to length.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
3/8" RED TUBE
Connected from reverse osmosis faucet to drain
adapter
1. Connect one end of the 3/8" red tube to the reverse
osmosis faucet by sliding the tube into the 3/8" brine
output.
2. The loose end needs to be attached to the quick connect
fitting on the sink drain adapter.
3. Cut this tube as needed to route it as straight as
possible, without loops, dips, or kinks.
4. Cut the end of the tube square.
5. Insert all the way into the fitting.
6. Pull on the tube to be sure it is held firmly in the fitting.
7. With remaining tube connect the other end of the
T-connector.
8. The loose end needs to be attached to the quick connect
fitting on the sink drain adapter.
9. Repeat step 3 thought 5.
1/4" WHITE TUBE
Connected from reverse osmosis assembly to
faucet
1. Connect one end of the 1/4" white tube to the reverse
osmosis faucet by sliding tube into the 1/4" tube input.
2. Route the loose end of this tube to the white collet fitting
on the Reverse Osmosis assembly.
3. Cut tube square and to length.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
1/4" RED TUBE
Connected from reverse osmosis assembly to
reverse osmosis faucet
1. Connect one end of the 1/4" red tube to the reverse
osmosis faucet by sliding tube into the 1/4" brine tube
input.
2. Route the loose end of this tube to the red collet fitting
on the Reverse Osmosis assembly.
3. Cut tube square and to length.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
1/4" YELLOW TUBE
Connected from reverse osmosis assembly to
T-connector
1. Connect one end of the 1/4" yellow tube to the yellow
collet fitting on the Reverse Osmosis assembly.
2. Route the loose end of this tube to the 1/4" quick
connect on the T-connector.
3. Cut tube square and to length.
4. Insert all the way into the fitting.
5. Pull on the tube to be sure it is held firmly in the fitting.
Installation Instructions
MAKE TUBING CONNECTIONS (cont.)
The illustration is for reference only, the actual product shall prevail
Faucet
Concentrated water
Concentrated water
Drain Clamp
Water inlet
Inlet three-way ball valve
Municipal tap water
Purified water
Drainage
POWER
INLET OUTLET
DRAIN 1 DRAIN 2
Filter element
indicator
Filter element touch key Power supply touch key
Failure indicator
Power supply
indicator
Interactive interface
Water purifier
3/8"White Tube
1/4"White Tube
1/4"Red Tube
1/4"Yellow Tube
3/8"Red Tube
3/8"Red Tube
To Next Page
Loading...
Need help?
General
