EasyManuals Logo

GE SmartWater GX1S01C User Manual

GE SmartWater GX1S01C
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
REQUIRED TOOLS FOR INSTALLATION
Slotted and Phillips screwdrivers
Pliers and adjustable jaw wrench
OPTIONAL KITS AND TOOLS FOR INSTALLATION
NOTE:
Installation kit (SSKIT), sump wrench (UCWRNCH)
and faucet (UNFCTBL or UNFCTWW) are sold separately
for model GX1S01C.
Hand- or battery-powered drill and
1
4 bit (saddle
valve installation)
Electric drill and drill bit to drill
3
4 hole (type as
required) if mounting hole is needed for faucet
Pipe cutter
File
CAUTION: To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures.
Special drill bits may be needed for porcelain or
stainless steel.
GX1S01C is
Tested and Certified
by NSF International against
NSF/ANSI
Standards 42 and 53
for the reduction of the claims
specified on the Performance
Data Sheet.
1
GE SmartWater
INSTALLATION INSTRUCTIONS
Water Filtration System model GX1S01C (Filters not included)
7239197 215C1044P032 (01-06 JR) 49-50191
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
SPECIFICATION GUIDELINES
Inlet-outlet–3/8 NPT
Service
Replacement Filter (not included) flow rate Capacity Pressure Temperature
FXUTC – Taste and Odor 1.0 gpm 3000 gal. or 6 months 40–125 psi 40–100°F
FXULC (rev. 2) – Lead and Cyst 0.6 gpm 600 gal. or 6 months 40–125 psi 40–100°F
SAFETY PRECAUTIONS
Check with your local public works department for
plumbing codes. You must follow these guidelines
as you install the Water Filtration system.
Use the Water Filtration system on a potable, safe-to-drink,
home COLD water supply only. The filter cartridge will not
purify the water, or make it safe to drink.
Do not use on a hot water supply (100°F. max.)
.
Install or store where it will not be exposed to temperatures
below freezing or exposed to any
type of weather. Water
freezing in the system will damage it.
Your Water Filtration system will withstand up to
125 pounds per square inch (psi) water pressure.
If your house water supply pressure is higher than 100 psi,
install a pressure reducing valve before installing the
Water Filtration system.
WARNING: Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems
certified for cyst reduction may be used on disinfected
water that may contain filterable cysts.
Discard all unused and packaging material after
installation. Small parts remaining after installation
could be a choke hazard.

Other manuals for GE SmartWater GX1S01C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE SmartWater GX1S01C and is the answer not in the manual?

GE SmartWater GX1S01C Specifications

General IconGeneral
BrandGE
ModelSmartWater GX1S01C
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals