How to operate your dishwasher
Cycls Indicator Dial
flurn to start)
m
STEP 1. Load your dishwasher
with dishes, silverware, pots,
pans, bowls, etc. according to
instructions on pages 8 and 9.
STEP2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator Dial is at OFF
position before adding detergent.
(See pages 6 and 7.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
make sure the rinse agent container
is at least half fidl. (See page 6.)
STEP 3. Select Drying Option.
HEATED ENERGY
ORYING SAVER
Elm
HEATED DRYING. Turns the
drying heater on for fast drying.
ENERGY SAVER(no-heat drying).
‘Ibms the drying heater off to save
energy. Dishes will dry naturally
over a longer period such as
overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycleis complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
model approximately 7% for the
NORMAL WASHcycle.
STEP4. Select the cycleand start
the dishwasher.(SeeCycle Selection
Hints at right.)
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher.
● For PCYI’SCRUBBERand
NORMAL WMH cycks:
POT- NORMAL
SCRUSSER WASH
6X3
a. Push selected cyclebutton.
b. Latch the door.
OFro.ou
● UQHT
@
WASH
DRYING
● RINSE ONLY
us‘&’m:MVIN6
c. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
There is a time delay between
start-up and water fill so you will
not hear any wash action right
away.
Toobtain the benefits of a complete
cycle, be careful that you do not
turn the dial any further than
neeessary to startthe dishwasher.
. For LIGHT WMH cycle:
a. Be sure door is unlatched.
b. Push NORMAL WASHbutton.
OFF O,ON
● Lla+-r
(Z!I
WASH
ORYING
I
● RINSE ONLY USf ‘&&%i?YIuG
c. Slowly turn Cycle Indicator
Dial to LIGHT WASHposition.
d. Latch door to start the cycle.
● ForRINSE ONLYcycle:
a. Be sure door is unlatched.
b. Select ENERGY SAVERdrying
option.
OFF O.ON
● LIGHT
(D
WASH
DRYING
● RINSE ONLY W ‘&&/m~
c. Slowly turn Cycle Indicator
Dial to RINSE ONLY position.
d. Latch the door to start the cycle.
4
——. .
I
To Next Page
Loading...
Need help?
General
