QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
OVEN
W~L
NOT COME
ON
CONTROL PANEL
LIGHTED,~T
OVEN
WILL NOT START
“PRObE” APPEARS
ON DISPLAY
FLOOR OF THE
OVEN IS WARM,
EVEN WHEN THE
OVEN HAS NOT
BEEN USED
POSSIBLE CAUSE
● A fuse in your home may be blown or the circuit breaker tripped. Replace fuse
or reset circuit breaker.
●
Unplug your microwave
oven,
then plug it back in.
G
Make sure 3-prong plug
on
oven is fully inserted into
wdl
receptacle.
●
Door not securely closed.
●
START pad must be touched after entering cooking selection.
●
Another selection entered already in oven and CLEANOFF pad not touched
to cancel it.
●
Make sure you have entered cooking time after touching TIME COOK I &
11
pad.
●
CLEAWOFF
pad was touched accidentally. Reset cooking program and touch
START pad.
●
Make sure you have entered a temperature after touching
TEMP
COO~OLD
pad.
●
Make sure you have entered a code number after touching AUTO ROAST pad.
●
Probe has been forgotten or not seated properly in oven wall
when
using
Temp
Coo~old
or Auto Roast function.
●
The
cooktop
lamp is located directly below the oven floor. When the lamp
is on, the heat it produces makes the oven floor get warm. This is
norrnd.
All
these things are normal with your microwave oven:
● Steam or vapor escaping from around the door.
● Dull thumping sound while oven is operating.
●
Light
reflection around door or outer case.
● Some TV-Radio interference might be noticed
● Dimming oven light and change in blower sound
may
occur while operating at power levels other
than high.
while using your microwave oven. It’s similar to
the interference caused by other
small
appliances
and does not indicate a problem with your oven.
If you need more help...call, toll free: GE Answer Center
@
/ 800.626.2000/ consumer information service
32
To Next Page
Loading...
