INSTALLATION REQUIREMENTS
IMPORTANT... PLEASE READ CAREFULLY
How to Connect Electricity
For persona_ salety, this
appliance must be
properly grounded.
The m,w er cord of tiff s
appli ante is equipped _ i ib a
3 F,rong (grounding) plug
which mate _ ith a smndatd
B-prong ( grounding tx_ail
outletlo ml n imizelhe
possibilily of electric shock
hazard l}om this appliance.
Preferred
method
Insure proper
grounding exists
before using.
Have the wall outlet and circuit checked by a qualified electrician to
nmke sure the outlet is properly grounded.
Where a standard 2-prong wall outlet is encountered, it is your
personal responsibility and obligation to have it replaced with a
properly grounded 3-prong wall outlet.
DO NOT. UNDER ANY CIRCUMSTAN(ES, CUT OR REMOVE
THE THIRD (GROUND) PRONG FROM THE POWER CORD.
Use of Adapter Plug
l"Iccatl_,e 01' potential
hazards ttllder certain
condition\," _ e strongly
recoil/mend agatn stuse
of at] adapter plug.
Hov_ c\ er. it' you still dect
rouse an adapter, \\ here
Iocalcodes permit, a
TEMPO P()RAR'_
(XINNECI'ION ma5 be
made to a properly
grounded 2-prong
\% ill {oIIt ICE b} tlSC I)l
a IJI Jistcd adaI)ter
avai htble at llIO_t lOt[I[
hardware q{ol'e >..
Temporary Method
(Adapter plugs not
}ermitted in Canada.)
Align large prongs/slots.
Insure propergroundin9 and firm
connection exists before use.
The larger _h)t in the adapter must be aligned with the larger slot in
the',_ all out!ct tOprtw ide proper polarity in the connection of the
po_ er cord.
[]se {}1"an adapter pt ug _vil I increase the clearance needed fl)r the back
of the _e fri_erator.
CAUTION: Attaching the adapter ground terminal to a wall outlet
cover screw does not ground the appliance unless the cover sc_ex_ is
recta< and not insulated, and the wall outlet is grounded through the
house wiring. You should have the circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
When disconnecting the power cord from the adapter, alwayshok/
the adapter in place with one hand while pulling the power cord phlg
with the other hand. If this is not done, the adapter ground temlinal is
very likely to break with repeated use.
Should the adapter ground terminal break, DO NOT USE the
appliance until a proper ground has again been established.
Electrical Requirements
The refrigerator should always be plugged into its own individual
electricaloutlet which has a oha_.,.e rating that matches the rating plate.
'!-his pro\ides the best performance and also prevents overloading house
wiring circuils hichcould cause a firehazard fi'om overheated wires.
Use of Extension Cords
Because of potential safety hazards under certain condition, we
strongly recommend against the use of an extension cord. Howe'. er. it'
you still elect to use an extension cord, it is absolutely necessar,,, that it
be a UI.-listed 3-wire grounding type appliance extension cord ha_ing
a grounding type plug and outlet and that the electrical rating of the
cord be 15 amperes (mininmm) and 120 volts.
14
To Next Page
Loading...