GE TONOPORT V - Controls and Indicators

Controls and Indicators
10 TONOPORT V 2001589-085 Revision G
2 Controls and Indicators
Fig. 2-1 TONOPORT V controls and indicators
Functions of the Button
1 Connection for blood pressure cuff
2 Button : push to display the most recent
parameter readings. Readings appear in the
following order:
- systolic value "S" (unit mmHg or kPa shown on the
display)
- d
iastolic value "D" (unit mmHg or kPa shown on
the display)
- p
ulse rate "HR" (unit min
-1
)
The same button is used
- t
o toggle between the day phase and the night
phase chapter 4, section "Toggle Manually Between
Day and Night Phase") and
- to program the BP monitor (chapter 3 "Setup")
3 Button : push to start and stop a
measurement, and to confirm entries
4 Liquid crystal display (LCD)
5 Port for connection to PC (USB)
6 Port for connection to PC (RS232)
7 Calibration mark
8 Lid covering battery compartment
9 (Rechargeable) batteries
10 ON/OFF switch
11 Nameplate
Button
Message
on
display
Function
Push once H 1 clear memory
Push twice H 2 set date and time
Push 3 times H 3 select the measurement
protocol
Push 4 times H 4 activate calibration mode
Push 5 times H 5 display firmware version
Push 6 times H 6 select energy source
Push 7 times H 7 enable/disable audio signal
Push 8 times H 8 toggle pressure unit between
mmHg and kPa
S
D
HR/min
-1
START
STOP
INFO
NBP
!
off 0 on I
TONOPORT V
1
2
3
4
8
11
10
9
6
5
7
INFO
INFO
INFO
START
STOP