What to do if my GE Blood Pressure Monitor displays error E 29?
If your GE Blood Pressure Monitor shows error E 29, tighten the cuff so that you can insert one finger, but not two, between your arm and the cuff. The device will then switch to a deflation rate of 4 mmHg/s.
General| Category | Medical Equipment |
|---|---|
| Measurement Method | Oscillometric |
| Measurement Principle | Oscillometric |
| Type | NIBP Monitor |
| Manufacturer | GE Healthcare |
| Display | LCD |
| Power Supply | Battery |
| Cuff Pressure Range | 0-300 mmHg |
| Operating Modes | Manual, Automatic |
| Measurement Range | See Systolic, Diastolic, MAP ranges |
Details regarding the manual's revision history, purpose, and intended audience.
Outlines GE Medical Systems' responsibility and general safety rules for operation.
Information on authorized servicing, warranty, and ESD precautions.
Visual representation of system components and explanation of operational modes.
Details on external interfaces, pin assignments, and device version information.
Key technical data including measuring range, battery, and operating conditions.
Steps for preparing and loading firmware version FW1.4 using Hyperterminal or Telix.
Steps for preparing and loading firmware version FW2.0 using the Windows Update Program.
Explanations for various diagnostic and error codes encountered during operation.
Calibration steps, internal component views, and technical safety/system inspection procedures.
Lists of manuals, accessories, and spare parts for the TONOPORT V.
Electrical schematics and PCB component layout diagrams for HW1.2 and HW2.0.
To Next Page
