GE Uninterruptible Power Supply User Manual

GE
modifications reserved Page 5/10
OPM_VCL_XXX_0K4_1K5_XGB_V012 User manual - VCL Series UPS 400-1500VA V012 - GB
1.3 WARRANTY
GE, operating through its authorized agents, warrants that the standard products will be free of defects in materials and
workmanship for a period as per contract specifications.
NOTE
This warranty does not cover failures of the product which result from incorrect installation, misuse,
alterations by persons other than authorized agents, or abnormal operating conditions.
1.4 STORAGE
Store the UPS in a dry location with the batteries in a fully charged state. Storage temperature must be within
-15 +55 C. If the unit is stored for a period exceeding 3 months, optimal battery lifetime is obtained if the storage
temperature does not exceed 25°C.
If the unit is stored for an extended period of time, the batteries must be recharged every 2 months.
CAUTION
In case of storage, pay attention to:
2 INSTALLATION & OPERATION
2.1 INTRODUCTION
The GE (General Electric) VCL Series UPS, a line-interactive uninterruptible power supply, has been designed to protect
your sensitive electronic equipment such as computers and telecommunications equipment from virtually all forms of
power interference, including complete power failures.
When the mains supply is present and the UPS is switched on, the UPS is charging the battery and providing power to the
connected equipment from the AC line directly. In case of a mains failure the reliable battery can provide the stable
power to complete your work, save the data and safely shut down your system.
Inspect the UPS for damage after unpacking. If any damage is present please immediately notify the carrier and place of
purchase.
WARNING! In case of recognizable damage:
DO NOT connect any voltage to the unit
DO NOT put the unit into operation.
Condensation may occur if the UPS system is moved directly from a cold to a warm environment. The UPS system must
be absolutely dry before being installed. Please allow an acclimatization time of at least two hours prior to installation.
Save the original packing material. No liability can be accepted for any transport damage when the equipment is shipped
in non-original packaging.

GE Uninterruptible Power Supply Specifications