Tri-plane AFI
Tri-plane AFI
Note:
Doppler acquisition is recommended for defining AVC
prior to going into tri-plane AFI
1. Acquire AoV Doppler image
2. Select Measure
3. Select event timing folder
4. Mark AoV Closure
(Tri-plane AFI – cont.)
Acquisition
1. Select 4D probe
2. Press Multi D button
3. Select Tri-plane on touch panel
4. Press Image Store
Tips: Set as default in Config-Imaging-Global-time before and after heart
cycle should be 100 ms
Ensure a full good ECG signal cycle during acquisition or in application tab,
set default to 3 cycles
Ensure all 3 views are aligned before storing the loops
To Next Page
Loading...
