(Biplane Prepare – cont.)
Rotary knobs
3. Use assigned knob to ROTATE the 2 lines (lines will always stay orthogonal)
around the center of the image
4. Use assigned knob to TILT the second plane (white) as used in regular
biplane mode
Trackball
5. Use trackball to move RIGHT
(clockwise) or LEFT (counter clockwise)
6. Use also trackball to tilt UP or DOWN
Biplane Prepare
The tool uses the 4D render image to orientate and
obtain biplane images with high frame rate and
high spatial resolution
1. While in 4D imaging, press Biplane prepare
button on the touch panel
2. Adjust the position of the Laser lines either
by using rotary knob or by trackball
4D Workflow Tools
Default Rotate +Tilt
To Next Page
Loading...
