Beforeyoucall forservice...
Troubleshooting tips
Save :timeand money/.Review the charts on the following pages
first and you may not need to call for service.
Possible Causes What ToDo
Washer_Won't Washer is unplugged
ii!iii!!iiiiiiiilli!iii!!!
ili:i_i_ii_iiii_i_iiiiili!!i_iii;iiii_iiii_ifillili!:ii!iiiili_iiiiiiiiiiiiiiiiiiii!i_iiii_!i!iiiii!;i!i_ii_iiiiiiii;iii!ililili!iiiiiiiiiiii:iiiii_iiiii_ililil
Controls are not set
properly
° Make sure cord is plugged
securely into a working
outlet.
*Turn both hot and cold
faucets fully on.
* Check controls and
make sure Cycle knob is
pulledout to 0Nposition.
Lid is open
Circuit breaker/fuse is
tripped/blown
Close lid and pull Cycle
knob out to ONposition.
Check house circuit
breakers/fuses. Replace
fuses or reset breaker.
Washer should have
separate outlet.
Control is not set properly * Check water temperature
control and adjust.
Water supplyis turned off * Turn both hot and cold
or improperly coimected faucets fully on and make
sure hoses are colmected
to correct faucets.
Water valve screens are
stopped up
* Turn off the water source
and remove the water
connection hoses from
the upper back of the
washer. Use a brush or
toothpick to clean the
screens in the machine.
Reconnect the hoses and
turn the water back on.
House water heater is
not set properly
Make sure house water :
heater is delivering water "
at 120°F.-140°F.
(48oc.-60oc.):
15
To Next Page
Loading...
