GE WCVH4800K - Page 7

GEAppliances.com
SiGNAL. ))
Signal
Whenthe light is"on,"the washer will
beep at the end of the cycle and every
time you pressa button on the control
panel.
Toturn the signal off, pressthe SIGNAL
button and the light will go off.
EXTRA RINSE
Extra Rinse
Use an extra rinse when additional
rinsing isdesired to remove excess dirt
and detergent from soiled loads.
DELAVSTART
Delay Start
Useto delay the start of your washer.
1. Chooseyour wash cycle and any
options.
Z PressDELAYSTARTbutton. Youcan
change the delay time in !-hour
increments (up to !8 hours)each time
you pressthe PELAYSTARTbutton.
Stoppressingthe button when your
desiredtime is displayed.
3. Pressthe START/PAUSEbutton to start
the countdown.
Thecountdown time will be shown in the
ESTIMATEDTIMEREMAININGdisplay.
NOTES:
If the door is opened while the washer
is in DELAY,the countdown time wi!!
continue to count down the delay
time. If the door is not closed and the
countdown time expires, the cycle wi!!
not start unti! the door is closed and
the START/PAUSEbutton is pressed.
m You can delay the start of a washer
cycle up to !8 hours.
The light on the button will light up when
DELAYSTARTis on.
;..,.--u--, ........ ,...;
HOLD 3 SECSTO
LOCK&UNLOCK
CONTROLPANEL
Lock
You can lock the controls to prevent
any selections from being made. Or
you can lock or unlock the controls
after you have started a cycle.
Children cannot accidentally start
the washer by touching pads with
this option selected.
To lock the washer, press and hold
the TEMPand SPIN buttons together
for 3 seconds.
To unlock the washer controls, press
and hold the TEMPand SPIN buttons
together for 3 seconds. A sound is
made to indicate the lock/unlock status.
The control lock icon on the display will
light up when it is on.
NOTE:The POWERbutton can stil! be
used when the machine is locked.
MYCYCLE
_ HOLD3
[] |i SECONDS
)_ TO STORE
My Cycle
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin
speed and wash temp settings and
hold down the MY CYCLEbutton for
5 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the MYCYCLEbutton before washing
a load.
To change the saved cycle, set
the desired settings and hold down
the MYCYCLEbutton for 5 seconds.
NOTE:When using MY CYCLE,
wash options cannot be modified
after the cycle has been started.
NOTE:If you change wash options
with MY CYCLEbefore starting the cycle,
the MYCYCLElight wi!! turn off and you
wi!! be returned to the base cycle.