GearLight S1200 - User Manual

To Next Page

S1200 LED FLASHLIGHT

User Manual

TROUBLESHOOTING

If the ﬂashlight ﬂickers, works intermittently, changes modes automatically, appears

dim or faded, or does not turn on, check and verify that:

• Each battery is fully inserted matching the polarity (+/-) on the battery holder.

• Each battery end is touching a metal contact in the battery holder.

• The battery holder contacts are clean and the springs are not bent sideways.

• The ﬂashlight's inner spring is ﬁrmly attached and not bent.

• The battery holder is inserted into the ﬂashlight with the positive (+) end ﬁrst.

• The tail cap is twisted on tightly.

Firmly press the power button on and o several times:

• If the ﬂashlight still does not turn on, replace the batteries.

• If the problem persists, contact GearLight for a replacement.

Irvine, California | USA | www.GearLight.com

WARRANTY AND LIMITATION OF LIABILITY

MAINTENANCE

Inspect the ﬂashlight monthly and carefully remove any damaged batteries and clean

any corrosion. If the ﬂashlight is used less than once a month, remove the batteries

between uses. Lubricate all threads and rubber O-rings with petroleum

jelly twice yearly.

Limited One-Year Warranty

GearLight warrants this product for one year from the date of purchase

against any defects in material or workmanship. This warranty does not cover

normal wear and tear, nor damage resulting from misuse or neglect. We will,

at our discretion, repair, replace, or refund the purchase price of this product

should we determine it to be defective.

Limitation Of Liability

Liability limited to the purchase price of this product. GearLight shall not be

liable for any incidental or consequential damages or any implied warranty on

this product. Some states do not allow the exclusion or limitation of

incidental or consequential damages, so the above limitation or exclusion

may not apply to you.

1x GearLight S1200 LED Flashlight

1x 18650 Battery Tube (Batteries Are Not Included)

1x AA Battery Holder (Inside Flashlight)

1x Lanyard

1x User Manual

1x Warranty Card

Package Contents:

FOR YOUR SAFETY, READ BEFORE OPERATING

IMPORTANT SAFETY NOTICE: Lithium-ion batteries are potentially hazardous and can present a

ﬁre, explosion, and burn hazard. By using lithium-ion batteries, you agree that GearLight shall not

be liable for any incidental or consequential damages arising from, relating to or connected with the

use of lithium-ion batteries. If you do not agree with these conditions, please use only alkaline or

NiMH rechargeable batteries.

Need help?

Do you have a question about the GearLight S1200 and is the answer not in the manual?

The GearLight S1200 LED Flashlight is a versatile and powerful illumination tool designed for various applications, from everyday use to more demanding situations. This user manual provides comprehensive instructions for its operation, maintenance, and safety, ensuring users can maximize its performance and longevity.

Function Description

The primary function of the GearLight S1200 is to provide bright, adjustable illumination. It features an LED light source capable of producing different levels of brightness, allowing users to select the appropriate intensity for their needs. The flashlight is designed for portability and ease of use, making it suitable for a wide range of activities such such as camping, hiking, emergency preparedness, or general household tasks. Its robust construction ensures durability and reliability in various environments.

Usage Features

The GearLight S1200 offers several user-friendly features that enhance its functionality and adaptability.

Powering the Flashlight:

The flashlight can be powered by two different battery configurations, offering flexibility to the user:

AA Battery Installation: For convenience, the flashlight can use three AA batteries. To install these, the user first unfastens the tail cap and removes the battery holder. Three AA batteries are then inserted into the holder, ensuring correct polarity as marked (+,-). Finally, the battery holder is reinserted into the flashlight with the positive (+) end first. It is crucial to always follow the battery manufacturer's instructions for proper usage, handling, storage, and disposal. Users should only use batteries from reputable manufacturers, avoid mixing different brands or types of batteries, and replace all batteries simultaneously to prevent personal injury or property damage.
18650 Lithium-ion Rechargeable Battery Installation: For extended use and higher performance, the flashlight can utilize a 3.7V 18650 lithium-ion rechargeable battery. To install, one 18650 battery is placed inside the provided clear 18650 battery tube. The combined battery and tube are then inserted into the flashlight with the positive (+) end first. A critical safety warning accompanies the use of lithium-ion batteries, as they can present a fire, explosion, and burn hazard. Users must only use 18650 battery cells with a protection circuit from specified manufacturers (Panasonic, Sanyo, Sony, Samsung, or LG). The battery should be removed when the flashlight is not in use. Failure to adhere to these safety instructions or using unauthorized cells can lead to severe personal injury and property damage. An important safety notice also highlights that lithium-ion batteries are potentially hazardous, and by using them, the user agrees that GearLight is not liable for any incidental or consequential damages. If these conditions are not agreeable, users should opt for alkaline or NiMH rechargeable batteries instead.

Operating the Flashlight:

On/Off Functionality: To turn the flashlight on, the user firmly presses down on the red power button located on the tail of the flashlight until a click is heard. To turn it off, the button is pressed firmly again until another click is heard.
Switching Modes: The GearLight S1200 features three distinct lighting modes: High, Medium, and Low. To cycle through these modes, the user gently presses down on the red power button. The flashlight will advance to the next mode with each quick press. If the flashlight is turned off and then on again in quick succession, it will switch to the next mode. However, if it remains off for more than 10 seconds, it will reset to the highest mode upon being turned on again.
Zoom Function: The flashlight incorporates a zoom feature, allowing users to adjust the beam focus. To zoom in, both ends of the flashlight are gently twisted and pulled away from each other. To zoom out, the two ends are pushed back together.

Safety Precautions:

Several warnings are provided to ensure user safety:

Users should avoid staring directly into the light beam or shining it into anyone's eyes to prevent eye injury. The product is not designed, intended, or recommended for children or hazardous environments.
A caution notes that the flashlight may become warm or hot during extended periods of use at the highest setting. If this occurs, users should select a lower setting. This is considered normal for high-powered flashlights and does not indicate damage.
It is advised to remove batteries if the flashlight is not working properly, as failure to do so may result in personal injury and property damage.

Maintenance Features

Proper maintenance is crucial for ensuring the long-term performance and reliability of the GearLight S1200 LED Flashlight.

Regular Inspection and Cleaning:

Monthly Inspection: Users should inspect the flashlight monthly. This includes carefully removing any damaged batteries and cleaning any corrosion that may have accumulated.
Battery Storage: If the flashlight is used less than once a month, it is recommended to remove the batteries between uses. This helps prevent battery drain and potential damage from leakage.
Lubrication: All threads and rubber O-rings on the flashlight should be lubricated with petroleum jelly twice yearly. This helps maintain the integrity of the seals, ensuring water resistance and smooth operation of movable parts.

Troubleshooting:

The manual provides a comprehensive troubleshooting guide for common issues:

Flickering, Intermittent Operation, Mode Changes, Dimness, or Failure to Turn On: If any of these issues occur, users should check and verify the following:
- Battery Insertion: Ensure each battery is fully inserted, matching the polarity (+/-) on the battery holder.
- Battery Contacts: Verify that each battery end is touching a metal contact in the battery holder.
- Holder Contacts: Check that the battery holder contacts are clean and that the springs are not bent sideways.
- Inner Spring: Confirm that the flashlight's inner spring is firmly attached and not bent.
- Holder Orientation: Ensure the battery holder is inserted into the flashlight with the positive (+) end first.
- Tail Cap: Make sure the tail cap is twisted on tightly.
Persistent Issues: If the flashlight still does not turn on after checking the above points, users should firmly press the power button on and off several times. If the problem persists, the batteries should be replaced. If the issue still remains, it is recommended to contact GearLight for a replacement.

Warranty and Limitation of Liability:

Limited One-Year Warranty: GearLight warrants the product for one year from the date of purchase against defects in material or workmanship. This warranty does not cover normal wear and tear, or damage resulting from misuse or neglect. GearLight reserves the discretion to repair, replace, or refund the purchase price if the product is determined to be defective.
Limitation of Liability: GearLight's liability is limited to the purchase price of the product. GearLight is not liable for any incidental or consequential damages or any implied warranty. The manual notes that some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to all users.

By following these usage and maintenance guidelines, users can ensure their GearLight S1200 LED Flashlight remains a reliable and effective tool for all their illumination needs.