What to do if water is constantly running in my Geberit Sigma10?
If water continuously runs into the WC ceramic appliance, it could be due to several reasons. A software fault might be the cause; try interrupting the power supply (mains fuse) for 10 seconds. Alternatively, the flat gasket for the flush valve or the fill valve may be defective, in which case you should replace the flat gasket or the fill valve.
Why is my Geberit Sigma10 releasing flushes on its own?
If your Geberit Plumbing Product is flushing automatically when you step away, the automatic flush actuation feature is likely enabled. You should deactivate this setting to prevent unwanted flushes.
How to fix incorrect flushes on Geberit Sigma10?
If your Geberit Plumbing Product is flushing incorrectly (too soon, too late, or unwanted), the issue might be a dirty, wet, or scratched sensor window. Try cleaning or drying the actuator plate. If the sensor window is scratched, you will need to replace the actuator plate.
What to do if my Geberit Sigma10 Plumbing Product flush cannot be released?
If the flush cannot be released, verify that the power supply (mains fuse) is working correctly, as a network failure could be the reason.
Why is my Geberit Sigma10 Plumbing Product not flushing properly?
If the WC ceramic appliance isn't flushing out properly, the flush volumes may be set incorrectly. Adjust the full flush volume on the flush valve and the partial flush volume using the Geberit Service Handy to the correct settings.
What to do if the LED flashes quickly and the Geberit Sigma10 Plumbing Product flush doesn't work?
If the LED in the sensor window flashes quickly and the flush cannot be released, ensure that the plug of the lifting device is correctly plugged in. If it is, and the problem persists, the lifting device may be defective and require replacement.
What to do if the LED is on, but the Geberit Sigma10 flush doesn't work?
If the LED in the sensor window lights up when a user is detected, but the flush doesn't work, the batteries are likely flat. Replace the batteries to resolve this issue.
What to do if the LED flashes and the Geberit Sigma10 flush doesn't work?
If the LED in the sensor window flashes when a user is in range and the flush cannot be released, the battery capacity is likely low. You should change the batteries.
General| Brand | Geberit |
|---|---|
| Model | Sigma10 |
| Category | Plumbing Product |
| Language | English |
To Next Page
