Need help?Do you have a question about the Geberit Mepla and is the answer not in the manual?
General| Application | Hot and cold water supply, heating systems |
|---|---|
| Temperature Resistance | Up to 70°C continuously, short-term peak temperature up to 100°C |
| Pressure Resistance | Up to 10 bar |
| Pipe Sizes | 16 mm to 75 mm |
| Connection Technique | Press fitting |
| Fittings Material | Brass |
| Approvals | DVGW, KIWA, WRAS |
| Standards | EN ISO 21003 |
| Material | Polyethylene (PE-RT) with an aluminium layer |
Specifies that the tool is intended for use by skilled professionals only.
Details the specific applications and approved tools for using Geberit Mepla pressing jaws.
Defines symbols used within the instruction manual for warnings and guidance.
Defines symbols that appear on the product itself, indicating hazards and service information.
Illustrates and labels the main components of the pressing jaw assembly.
Explains the procedure for correctly fitting the pressing jaw into the pressing tool.
Details the correct method for positioning the pressing jaw onto the press fitting.
Specifies the mandatory rules and intervals for maintaining the pressing jaws and tools.
To Next Page
