EN
19
B249-005 © 12-2013
964.874.00.0 (04)
Operation
Inserting the pressing jaw in the pressing tool
Placing the pressing jaw on the pressfitting
The procedure for inserting the pressing jaw depends on
the type of pressing tool and is therefore described in the
operating instructions of the pressing tool.
WARNING
Risk of injury caused by flying fragments if used
incorrectly or if worn or damaged pressing jaws are used
` Only use the pressing jaw if it is in perfect working order
(see the basic safety notes)
` Make sure that the diameter of the pressfitting matches
the diameter of the pressing jaw
` Do not tilt the pressing jaw on the pressfitting
` Clean away any dirt, chips or the like between the
pressing jaw and the pressfitting
` If the pressing jaw has been used incorrectly, or in a way
that does not comply with its intended use, do not
continue to use it and have it inspected by an authorised
repair shop
` Wear suitable protective equipment (protective goggles
etc.)
To Next Page
Loading...
