17MSPA-MP Metapacks Service Manual
Flashing Dots & LED Displayed
If keypad display isn't showing correct temperature, carry out the
following tests:
2• Make sure temperature probe
is properly connected.
If it is, replace probe and reset
breaker.
3• Replace board if error condition
still persists. (Refer to "How to
Replace the Board" section of
this manual.)
1• Verify if temperature probe
is in contact with water and if
cold air from the back could
be affecting readings.
Use foam to isolate probe from
cold air if that is the problem.
To Next Page
Loading...
Need help?
General