Gefen EXT-AVCONFS - Page 33

30
RS-232 SERIAL COMMANDS
BASS Command
The BASS command sets the bass level.
Syntax:
BASS param1
Parameters:
param1 Level [-12 ...12]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the bass level by 1 dB.
Use ? for param1 to retrieve the current value.
Example:
bass + // increases the bass level by 1 dB
bass - // decreases the bass level by 1 dB
bass 5 // sets the bass level to +5 dB
DFL Command
The DFL command sets the distance of the Front Left speaker.
Syntax:
DFL param1
Parameters:
param1 Level [0 ...10]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the Front Left distance by 1 foot intervals.
Use ? for param1 to retrieve the current value.