31
RS-232 SERIAL COMMANDS
DFR Command
The DFL command sets the distance of the Front Right speaker.
Syntax:
DFR param1
Parameters:
param1 Level [0 ...10]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the Front Right distance by 1 foot intervals.
Use ? for param1 to retrieve the current value.
DRC Command
The DRC command adjusts the Dynamic Range Control.
Syntax:
DRC param1
Parameters:
param1 Value
Value Meaning
OFF Turn DRC Off
ON Turn DRC On
TGL Toggle DRC
Notes:
Setting param1 to TGL will automatically toggles the current state of the DRC
command. This is the non-implicit form of switching DRC ON or OFF.
Use ? for param1 to retrieve the current value.
To Next Page
Loading...