35
RS-232 SERIAL COMMANDS
SUBV Command
The SUBV command sets the subwoofer volume.
Syntax:
SUBV param1
Parameters:
param1 Level [-10...10]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the subwoofer volume by 1 dB intervals.
Notes:
Use ? for param1 to retrieve the current value.
SUBX Command
The SUBX command adjusts the crossover frequency. This specifi ed value
defi nes the point, on the frequency spectrum, where are rolled off to the
subwoofer.
Syntax:
SUBX param1
Parameters:
param1 Value
Value Meaning
50 50 Hz roll-off
60 60 Hz roll-off
90 90 Hz roll-off
Notes:
Use ? for param1 to retrieve the current value.
To Next Page
Loading...