34
RS-232 SERIAL COMMANDS
RTV Command
The RTV command sets the Front Right speaker volume.
Syntax:
RTV param1
Parameters:
param1 Level [-10...10]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the Front Right speaker volume by 1 dB intervals.
Use ? for param1 to retrieve the current value.
SUB Command
The SUB command enables or disables the subwoofer. If a subwoofer is not
connected, the subwoofer should be disabled.
Syntax:
SUB param1
Parameters:
param1 Value
Value Meaning
OFF Disable the subwoofer
ON Enable the subwoofer
TGL Toggle subwoofer state
Notes:
Setting param1 to TGL will automatically toggle the current state of the
subwoofer. This provides a non-implicit form of enabling or disabling the
subwoofer.
Use ? for param1 to retrieve the current value.
To Next Page
Loading...