45
RS-232 SERIAL COMMANDS
PMODE Command
The PMODE command loads a predefi ned color and brightness calibration which
is applied to the output signal.
Syntax:
PMODE param1
Parameters:
param1 Mode
Mode Meaning
std Standard picture mode
mov Movie mode
vivd Vivid colors mode
user User defi ned
Notes:
Use ? for param1 to retrieve the current value.
RED Command
The RED command sets the green color component value.
Syntax:
RED param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the color component value by intervals of 1.
Use ? for param1 to retrieve the current value.
To Next Page
Loading...