46
RS-232 SERIAL COMMANDS
SATURTN Command
The SATURTN command sets the saturation level of the output signal.
Syntax:
SATURTN param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the saturation value by intervals of 1.
Use ? for param1 to retrieve the current value.
SHARP Command
The SHARP command sets the sharpness level.
Syntax:
SHARP param1
Parameters:
param1 Value [0...100]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the sharpness by intervals of 1.
Use ? for param1 to retrieve the current value.
To Next Page
Loading...