gefran BDI50-3055-KBX-4-NP-F - Page 97

4-50
04-11
Analog Output (AO) function selection.
Range
【
0
】
:Output frequency
【
1
】
:Frequency Setting
【
2
】
:Output voltage
【
3
】
:DC Bus Voltage
【4】:Output current
Example: Set 04-11 required according to the following table.
0
10V
Xmax
A
Xmax( 04-11)
Xmax / 2
5 V
04-12
AO Gain
Range
【
0 ~ 1000
】
%
04-13
AO Bias
Range
【
0 ~ 100
】
%
04-14
AO Bias Selection
Range
【
0
】
: Positive
【
1
】
: Negative
04-15
AO Slope
Range
【
0
】
: Positive
【
1
】
: Negative
 Select the Analog output type for the multifunction analog output on terminal (TM2)
as required by parameter 04-11. Output format is 0-10V dc.
The output voltage level can be scaled and modified by parameters 04-12 to 04-15 If
necessary.
 The modification format will be same as the examples shown previously for Analog Voltage
Input (AVI) parameters 4-02 to 4-05.
Note: the max output voltage is 10V due to the hardware of the circuit.
Use external devices that require a maximum of 10V dc signal.
04-16
Potentiometer / frequency curve gain setting
Range
【
0 ~ 1000
】
%
04-17
Potentiometer / frequency curve bias (offset) setting
Range
【
0 ~ 100
】
%
04-18
Potentiometer / frequency curve bias (offset) signe selection
Range
【
0
】
: Positive
【
1
】
: Negative
04-19
Potentiometer / frequency slope of the curve selection
Range
【
0
】
: Positive
【
1
】
: Negative
 Setting of frequency (main / alternative) by potentiometer on integrated keypad.
04-11
A
Xmax
【
0
】
Output frequency
upper frequency limit
【
1
】
Frequency Setting
upper frequency limit
【
2
】
Output voltage
Motor Rated Voltage
【
3
】
DC Bus Voltage
220V：0~400V
380V
：
0~800V
【
4
】
Output current
2 times rated current
of inverter