Switches
Auxiliary Hydraulic Switches
Auxiliary Hydraulic Buttons (A), (B)
Press these buttons to control the flow of the
oil in the auxiliary hydraulic circuit.
(A) ............. Hydraulic oil flows to auxiliary
hydraulic line (a)
(B) ............. Hydraulic oil flows to auxiliary
hydraulic line (b)
The button turns on the flow when it is
pressed, and turns off the flow when it is
released.
When one-way flow is selected by turning
on the flow selector switch (C), the
auxiliary hydraulic button only functions
when button (A) is pressed.
Refer to page 81 “Operating the Auxiliary
Hydraulics”.
Slider Switch
(Proportional control)
Proportional control allows for slow-to-fast
movement of auxiliary functions.
Example: If you move the slider switch
half way, the auxiliary function will move at
approximately one-half speed.
Move this switch to control the flow of the oil
in the first auxiliary hydraulic lines.
Flow Selector Switch (C)
The flow of the auxiliary hydraulic system
(lines (a) and (b)) can be set to either one-way
or two-way flow. When the switch is pressed,
the flow switches from two-way to one-way
and the built-in lamp (green) lights. When
pressed again, the flow switches from one-
way back to two-way and the lamp turns off.
OFF(O) ......Two-way flow
ON ( I ) ..... One-way flow
The oil in line (b) returns to the
hydraulic tank.
To Next Page
Loading...