Switches
High-Flow Switch (E) - (If equipped)
This switch controls the ON / OFF function of
the high-flow auxiliary hydraulics.
Press this switch to activate the high-flow
hydraulics and the hydraulic flow switches
from two-way to one-way and the built-
in lamp and flow selector switch lamp
(green) come on. Press this switch again to
deactivate the high-flow hydraulics and the
hydraulic flow switches from one-way back
to two-way and the lamps go out.
Refer to page 63, “High-Flow Hydraulic
System”.
O .........OFF
I ..........ON
Detent Mode Switch (D)
This switch changes the function of auxiliary
hydraulic button (A). Normally auxiliary
hydraulic flow is on while button (A) is pressed
and turns off when it is released. If pressed
again after pressing this switch, then auxiliary
hydraulic button (A) turns on and stays on
when it is pressed, and only turns off when it
is pressed again. The built-in lamp (orange)
lights when the switch is on. Thus there is no
need to hold the switch in. When this switch
is pressed again, the function of the auxiliary
hydraulic switch returns to normal and the
lamp turns off.
To Next Page
Loading...