913287/BP0808 56 PRINTED IN U.S.A.
The following initial oil and filter changes should be
made at 100 hours on a new machine. Thereafter these
changes should be made at the regular maintenance
intervals. Refer to the maintenance schedules for the
necessary procedures.
Engine Oil and Filter (250 Hours)
Transmission Oil and Filter (1000 Hours)
Hydraulic Return Filter (1000 Hours)
NOTE: Perform all other service requirements up
to this point as well as the following:
CHECKING AXLE OIL LEVELS
Differentials
NOTE: The Telescopic Handler should be on a
level surface for this procedure.
Remove each oil level check/fill plug, (see illustra-
tion). Oil should flow out the hole. If low, fill until oil
flows out the hole. When oil overflows, replace the
plug, wait 10 to 15 minutes and repeat the check/fill
procedure. Continue this process until the differential
is full. See the Lubrication chapter of this manual for
the proper oil specification. Replace the oil level
check/fill plug.
Planetary Hubs
NOTE: The planetary hubs can be checked with-
out jacking up the machine.
The planetary hubs have one plug each used for filling
and draining (see illustration). For checking the level
and filling, position the wheel until the plug is hori-
zontal. Remove the check/fill plug. If oil does not run
out, add oil until it overflows. Check the other hubs the
same way. Refer to the oil specifications in the
Lubrication chapter of this manual.
CHECKING TRANSFER CASE OIL LEVEL
Remove the oil level check plug. Oil should flow from
the hole. If low, remove the breather cap located on the
front side of the transfer case. Fill with the proper oil
until oil flows from the check hole. Replace the check
plug and the breather cap.
CHANGING FUEL FILTER
The frequency of filter replacement will be determined
by the cleanliness of available fuel, the care used in
storing fuel supplies and the operating conditions in
which the machine is used.
Planetary Oil
Check/Fill Plug in
Check/Fill Position
Service Every 250 Hours or Quarterly
Differential Oil
Check/Fill Plug
Transfer Case
Check Plug
100 Hours (New Machine Only)
Courtesy of Crane.Market
To Next Page
Loading...
Need help?
General
