GEIGER GJ56 e Series - Page 8

8
Gerhard Geiger GmbH & Co. KG | 100W1503 1118V001en
EN
EN
Setting GJ56..e4
I
The order of the adjustment process must be strictly adhered to and
the adjustment must always be completely implemented (all steps).
I
The motor GJ56..e4 is set up with a learning mode. During assembly
please begin the setting with step 1 and then go over to step 7.
1. Connect the setting switch to the GJ56..e and then plug in power supply
2. Press the programming button till the LED flashes (1 flash light, break, 1 flash light,
break,…) then release the programming button.
3. Setting of the lower end position: press the direction keys to exactly run the GJ56..e to
the desired lower end position.
4. Press the programming button till the LED flashes (2 flash lights, break, 2 flash lights,
break,…) then release the programming button
5. Setting of the shade position: press the direction keys to exactly run the GJ56..e to the
desired position.
6. Press the programming button till the LED flashes (3 flash lights, break, 3 flash lights,
break,…) then release the programming button
7. Run the blind to the upper end position. The motor turns off via torque recognition.
8. Press the programming button till the LED keeps lighting. The adjustment procedure is
completed.
Setting GJ56..e5
I
The order of the adjustment process must be strictly adhered to and
the adjustment must always be completely implemented (all steps).
1. Connect the setting switch to the GJ56..e and then plug in power supply
2. Press the programming button till the LED flashes (1 flash light, break, 1 flash light,
break,…) then release the programming button.
3. Setting of the lower end position: press the direction keys to exactly run the GJ56..e to
the desired lower end position.
4. Press the programming button till the LED flashes (2 flash lights, break, 2 flash lights,
break,…) then release the programming button
5. Setting of the upper end position: press the direction keys to exactly run the GJ56..e to
the desired upper end position.
6. Press the programming button till the LED keeps lighting. The adjustment procedure is
completed.
I
When using an external setting switch, the UP and DOWN keys must
be activated simultaneously – instead of the programming key.
Instead of the lighting up of the LED, the motor reacts with a short
back and forth movement.