64
MANUAL MIXING VALVE (Timer VT 2000 - VT 1000 - ET 500)
To check the proper working of the manual mixing valve, operate as follows:
- completely open a tap and run water;
- act on the by-pass lever with small movements until the value of the water
hardness measured at the outlet corresponds to the desired one.
HOW TO CHECK/ ADJUST THE HEIGHT OF THE BRINE VALVE
(Reserved to Technical Assistance Service)
Brine Valves are placed to a certain height according to the model of
water softener.
To check the proper adjustment of the valve, take out the brine valves
with the floats from the traps and measure the height with a rule by
checking it corresponds to the height shown in the table.
Water 15°f
Incoming
water
Water
hardness
0°f
Manual
mixing
valve
To Next Page
Loading...