ENGLISH
67
11.3 - HOW TO STOP THE SOFTENER
If the softener has not been used for a period longer than 10-14 days, it is necessary to unplug the
power supply, close the on-off valves before and after the system and open the by-pass gate valve
(see installation drawings at sections 9.2 – 9.3 – 9.4).
After this non-use period, connect the power supply again, open the on-off valves before and after the
system and close the by-pass gate valve.
Carry out a manual regeneration. To launch this operation, press key .
To Next Page
Loading...
