GEL DECAL - Overflow Display Conditions for Duplex; Duplex Softener Regeneration Process

84
If this higher water demand lasts for more than one minute, the display of the timer A MASTER will show
the following:
In these conditions vessel B will help vessel A and starts producing water.
When the requested water flow rate comes back below the maximum flow rate of the softener, the Master
Timer will show the initial display again:
Vessel A (MASTER) will supply the whole amount of water requested, while vessel B (SLAVE) is back in
stand-by mode.
14.2 REGENERATION
Once the time set in the regeneration mode has passed, the resins regeneration of vessel A (MASTER) will
start automatically.
Automatically:
- vessel A (MASTER) starts regeneration cycle
- vessel B (SLAVE) will supply the requested water.
Once activated, manual regeneration will carry out the 4 stages and then will automatically go in stand-by
again.
3
CLOCK . . . . . . . . . . . . . . . . . . .17:20
REG. TIME DD =4 H=02
IN= 28 °F OUT= 15 °F
TO CHANGE PRESS A
A = OVERFLOW B = HELP
4
CLOCK . . . . . . . . . . . . . . . . . . .17:20
REG. TIME DD =4 H=02
IN= 28 °F OUT= 15 °F
TO CHANGE PRESS A
A = ON B = OFF
5
CLOCK . . . . . . . . . . . . . . . . . . .17:20
REG. TIME DD =4 H=02
IN= 28 °F OUT= 15 °F
TO CHANGE PRESS A
A = REGEN. IN PROGRESS