GEM 1436 cPos - Remote Mounting to Quarter Turn Actuators

www.gemu-group.com22 / 76GEMÜ 1436 cPos
11 Assembly
1
4
6
3
2. Mount the mounting bracket 6 on the actuator 3 using the
screws, washers and spring washers provided.
11.9 Remote mounting to quarter turn actuators
7
6
4
3
1
NOTICE
▶ The travel sensor's cable exit protective coating is not UV-
resistant and must therefore be protected against direct
exposure to weather.
7
6
4
3
7
4
6
3
1. Fix the positioner 1 somewhere suitable.
NOTICE
Mounting bracket
▶ The GEMÜ 1436 000 ZMP mounting bracket, which is
available separately, can be used for this.
2. Mount (see “Rotary travel sensor mounting kit assembly“,
page19)the travel sensor mounting kit.
NOTICE
Installation position
▶ Observe the correct orientation of the operating range of
the rotary travel sensor (see “Checking the mechanical
mounting“, page23).
3. Place the travel sensor 7 with adapter 4 and mounting
bracket 6 on the actuator 3.