Page6
owners manual
Prp700-Prp800
DATA
BALANCE
DATA
BALANCE
ETC.
EFX: Selecting an effect in a preset
Each of the piano presets can include an EFX. The effect type selection is notifi ed by the correspond-
ing led on the panel. Press the EFX button to change the effect.
The preset PIANO1
has the effect OFF
(all leds are off).
Edit the effect send value for a selected preset
It is possible to customize the default effect level
set from the factory. Keep the EFX button pressed
for more than two seconds. The section leds start
fl ashing
The display enters the effect send edit mode
showing:
At this point press the BALANCE/DATA button >.
The fi rst time you press the button the display will
show the current send level value, the next time you
press the button, the value will be modifi ed.
Using a LAYER or SPLIT mode sound, is it possible
to change the effect sends for any of the enabled
sections. Enter in effect send edit mode.
Press the SELECT/TEMPO button >, the display
switches to the layer section
The editing procedure is the same as in the main
sound section.
Pressing the SELECT/TEMPO button > , the di-
splay switches to the split section
In this way the effect send of the split section may
be properly adjusted.
Increase
value
Decrease
value
To Next Page
Loading...
Need help?
General
