Need help?Do you have a question about the Gema CM30 and is the answer not in the manual?
General| Brand | Gema |
|---|---|
| Model | CM30 |
| Category | Control Unit |
| Language | English |
Initiate system power by turning the key switch to the 'on' position.
Interact with the CM30 Magic Control touch screen interface.
Authenticate system access by entering user credentials.
Execute the procedure to calibrate the system's axes.
Choose the operational mode for powder coating.
Insert powder bag and FP lance into the cone for operation.
Choose the operating mode for powder disposal or initial setup.
Verify the correct placement of the recovery powder hose.
Conclude the cleaning cycle and return to a standard operating state.
Place the system in a low-power standby state.
Safely power down the system by exiting all modes and switching off.
Transition from the active coating process to another operational state.
Activate the system's cleaning program.
Close doors and clean external gun surfaces prior to internal cleaning.
Execute the coarse cleaning procedure for the spray booth.
Leave the current coating program on the OptiCenter interface.
Choose the cleaning function within the OptiCenter.
Choose between 'Schnell' (quick) or 'Qualita' (quality) cleaning.
Position lance and cone for powder emptying and cleaning.
Reposition the recovery hose and FP cone for the next cleaning step.
Approve automatic sequence progression and manual cleaning actions.
Perform cleaning of the OptiSpeeder component and replace the cover.
Attach the RP hose to the designated 'Cleaning' connection.
Thoroughly clean the OptiCenter, booth, ducting, and sieve.
Initiate the cleaning process for the recovery hose.
Clean the cone and cyclone, using a single nozzle for the cyclone.
Reinsert the sieve and secure the cyclone after cleaning.
Conclude the cleaning sequence and return to normal operation.
Choose the mode for spraying powder directly to waste.
Verify the RP hose position after mode selection.
Manage system states and modes via the CM30 control panel.
Access functions for managing powder supply and settings.
Navigate to and select available coating programs.
Adjust the speed of material transport.
Manage user accounts and access levels.
Configure parameters such as powder output, voltage, and current for each gun.
View and manage individual gun activation and spraying status.
Navigate to axes parameters, error handling, and program management.
Set parameters for axis movement, speed, and spraying distance.
Manage axis activation, referencing, and start/stop functions.
Be aware of potential collision risks and safety precautions.
To Next Page
