Rev. 00 03/19
OptiFlex Pro B Maintenance / Repairs
43
Reinigung
Cleaning
Large dust formation possible!
If no dust mask or one of an insufficient filter class is worn when
cleaning the product, then the dust that is stirred up from the
coating powder can cause respiratory problems.
► The ventilation system must be turned on for all cleaning work.
► A dust mask corresponding to filter class FFP2 or N95 at
minimum must be worn during any cleaning work.
Gun cleaning
Impermissible solvents
The following solvents may not be used to clean the gun:
► Ethylene chloride, acetone, ethyl acetate, methyl ethyl ketone,
methylene chloride, premium gasoline, turpentine,
tetrachloromethane, toluene, trichloroethylene, xylene!
Only cleaning agents with a flash point of a least 5 Kelvin above
the ambient temperature, or cleaning places with technical
ventilation are allowed!
Before cleaning the powder gun, switch off the control unit. The
compressed air used for cleaning must be free of oil and water!
Daily:
1. Blow off the outside of the gun and wipe, clean etc.
Weekly:
2. Remove powder hose
3. Remove the spray nozzle from the gun and clean it with compressed
air
4. Blow through the gun with compressed air, beginning from the
connection in flow direction
5. Blow through the gun with compressed air, beginning from the
connection in flow direction
6. Clean the integrated gun tube with the brush supplied if necessary
7. Blow through the gun with compressed air again
8. Clean the powder hose
9. Reassemble the gun and connect it
To Next Page
Loading...
Need help?
General
