Gema OptiFlex Pro B User Manual

Rev. 00 03/19
44

Maintenance / Repairs OptiFlex Pro B
Cleaning the fluidizing/suction unit
ATTENTION
Damage to the fluidizing pads
► Never clean the fluidizing pads with solvents or water!
1. Remove the injector
2. Remove PowerClean module**
3. Remove the fluidizing/suction unit
4. Clean the fluidizing/suction unit with compressed air. Also blow off
the suction tube with compressed air
5. Clean the injector (see therefore the injector user manual)
6. Clean rinsing module**
7. Reassemble the individual parts
Repair work
In the event of malfunctions or faults, the product must be checked and
repaired by an authorized Gema service workshop. The repairs must only
be performed by an authorized specialist.
Improper tampering can result in serious danger for user and equipment.
Periodic checks
The periodic checks include examining all connecting cables and hoses.
The corresponding parts should be replaced immediately if any damage
to cables or hoses is discovered.
All plugs must be properly tightened.

Gema OptiFlex Pro B Specifications

General

Brand	Gema
Model	OptiFlex Pro B
Category	Paint Sprayer
Language	English