Gemas PURITRON GSC 30 User Manual

GEMAS pH CONTROLLED
PURITRON
SALT WATER CHLORINATOR
INSTRUCTION MANUAL
1. Introduction
2. Salt Water Chlorinator Description
3. Installation
4. Water Preparation
5. Salt Addition
6. Operating
7. Recommendations
8. Technical Characteristics
9. Warranty, After-Sales Service and Spare Parts

Gemas PURITRON GSC 30 Specifications

General

Brand	Gemas
Model	PURITRON GSC 30
Category	Swimming Pool Filter
Language	English

Summary

Installation

Control Unit Installation

Electrical Connections

Details on connecting the ground wire, phase, and neutral to the pump contactors for proper power supply.

Cell Housing and Bypass Installation

Cell Height Warning

Warning about potential damage to filtration elements from gases if the cell is installed below the output filter.

pH Flow Cell Installation

Water Preparation

Salt Addition

Salt Dissolving Process

Instructions for adding salt to the pool, emphasizing complete dissolution to prevent cell damage.

Operating

Chlorinator Controls

Setting Chlorine Production

pH Mode Setup

Guide to accessing and configuring pH settings, including turning the dosage pump on, off, or to automatic mode.

pH Settings Configuration

Instructions for setting the desired pH level, buffer selection, and tolerance for the dosing pump operation.

pH Calibration

Procedure for calibrating the pH sensor using pH 4 and pH 7 solutions for accurate readings.

Fault Messages

Interpretation of common fault messages like 'LOW SALT' and 'WATER LEVEL LOW' and troubleshooting steps.

Technical Characteristics

Warranty, After-Sales Service and Spare Parts

Warranty Coverage

Conditions for Warranty Exclusion