stop playing that disc and return to the beginning of the track or the set cue point.
33. CROSSFADER: The CROSSFADER allows you to mix evenly from one source to another. The
CROSSFADER on the CDM-4000 is also removable and if the need arises can be replaced. The RG-45 (RAI
LGLIDEn DUAL-RAIL CROSS FADER. which has internal dual stainless steel rails that allow the slider to ride
smoothly and accurately from end to end can be purchased from your local GEMINI dealer.
34. USB: Insert the VSB memory device into the VS8 input on the top of the CDM-4000.
35. SOURCE SELECT: The SOURCE SELECT allows you to choose the media from which you will play music
(CD/ USB):
NOTE WHEN USING THE CROSSFADER LIGHTLY GLIDE THE FADER BACK AND FORTH. PRESSING
DOWN ON THE CONTROLS CAN BEND CONTACTS AND CAUSE A LOSS OF SOUND.
FADER REPLACEMENT:
1. UNSCREW THE FADER SCREWS. DO NOT TOUCH INSIDE SCREWS CAREFULLY REMOVE THE OLD
CROSSFADER AND UNPLUG THE CABLE.
2. PLUGIN THE NEW CROSSFADER INTO CABLE AND PLACE BACK INTO MIXER.
3. SCREW THE CROSSFADER TO MIXER WITH THE FADER PLATE SCREWS
4. REPLACE THE FACE OF THE MIXER AND SCREW THE FOUR SCREWS BACK IN AND REPLACE THE
FADER KNOBS.
TROUBLESHOOTING:
– If a disc will not play. check to see if the disc was loaded correctly (label side up). Also, check the disc for excessive
dirt. scratches. etc.
– If the disc turns but there is no sound, check the cable connections, if they are ok. check your amplifier or receiver.
– If the CD skips, check the CD for dirt or scratches. Do not assume that the CD player is defective. Many CDs are
recorded out of spec and will skip on most or all CD players. Before sending the unit for repair, try playing a CD that
yOu are sure plays properly.
SPECIFICATIONS:
GENERAL:
Type……………………………………………… Compact Disc Player
Disc Type……………….. Standard Compact discs (12 cm & 8 cm)
Time Display……… Track Elapsed, Track Remain, or Total remain
Variable Pitch…………………….. 312% Slider with Resume Switch
Pitch Bend……………………………………………….. 316% Maximum
Instant Start……………………………………… Within 0.03 seconds
Installation…………………………………………………………. 1Y each
Dimensions………………. 19″ x 3.5″ x 10″ (482.6 x 88.9 x 254 mm)
Weight…………………………………… Main unit: 11.35 lbs. (514 kg)
AUDIO SECTION:
Quantization…………………… 1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate………………………………………………. 8 Times
Sampling Frequency…………………………………………… 44.1 kHz
Frequency Response………………………………… 20 Hz to 20 kHz
Total Harmonic Distortion…………………………. Less Than 0.05%
Signal to Noise Ratio……………………………………………….. 85 dB
Dynamic Range………………………………………………………. 85 dB
Channel Separation………………………………………. 85 dB (1 KHz)
Output Level………………………………………… 2.0 +/- 0.2V R.M.S.
Power Supply………………………………… AC 115/230 V, 60/50 Hz
INPUTS:
Phono………………………………………………………. 3mV,47 KOhm
Line…………………………………………………….. 150 my. 27 KOhm
MIC……………………………………………………..15 mV1K0 balanced
OUTPUTS:
To Next Page
Loading...
