17
Reset System Trouble? System troubles display and sound at the keypad.
Correcting the trouble will clear most indications, however the following error codes
will require manual reset: E13; E19; E20 and E22. (See SYSTEM TROUBLE ERROR
CODES for a description of error codes.)
Reset Sensor Watch Failure? (Sensor Watch programmed? qYES qNO).
Your system may have been programmed for Sensor Watch, a feature which
supervises the motion sensors in the system. If a Sensor Watch failure occurs, a
System Trouble E22-NN will result, where NN represents the zone number of the
sensor in question. To reset, press C to clear the display, enter the Function
Menu, scroll to ”RESET SENSOR MSG“ and pressJ. If you cannot correct the
problem, call for service
Start Exit Time? (Optional) (Start Exit Time programmed? qYES qNO)
In Commercial Burglary systems, exit delay may have been programmed to start after
a central-station “ringback” (verification) signal has been received. If the ringback tone
has not been received within about 30 seconds after arming, a communication
problem may exist. Use this function to start exit delay manually, then exit the
premises immediately. Be sure to have your alarm specialist check communications
with the central station as soon as possible.
RESET
SYS TRBL Y/N
RESET
SENSOR MSG Y/
START
EXIT TIME Y/
KEYPAD FUNCTIONS
To Next Page
Loading...
Need help?
General
