6
Caution:
Always make sure that the machine is unplugged from the
power source and the main swit
machine is not in use and before inserting or removing
parts.
- This machine is equipped with a polarized plug which
must be used with an appropriate electrical outlet.
- Connect the machine to a power source as illustrated.
(Pic 1 and Pic 2)
- The power switch is located above the terminal box.
Your machine will not operate unless this switch is on
(“l”). (Pic 1)
- Sewing light turns on automatically when the main
switch is on (“l”).
- To start the machine, press the foot control (Pic 3).
The speed of the machine is regulated by the amount of
pressure exerted on the foot control.
Attention:
Connecting the Machine to a Power Source
Consult a qualified electrician if in doubt when connecting
the machine to a power source. Unplug the power cord
when the machine is not in use. The appliance must be
used with the foot controller included.
To Next Page
Loading...
Need help?
General