geminox THR 10-100 Series User Manual


23(5$7,1*)$8/76
  'LVSOD\RIFRPPXQLFDWLRQRQWKH336
  7HPSHUDWXUHUHDGLQJHUURU
%HQHILWV
- Display of the different room units,
- Verification of the communication with the connected room units and of the BMU.
6HWWLQJ
- Using the line selection buttons, select programming line 62.
- The + / - buttons do not enable any setting.
- Note:
If it is an analogue input signal, the address of the unit is not displayed and selection
with the + / - buttons is not possible.
(IIHFW Accessing the programming line automatically activates the display of the status of the
PPS communication.
In the event of correct communication, the identification of the connected unit is
displayed in digital which defines the unit.
'LVSOD\V The displays differ according to the signal chosen for input A6, digital or analogue (line
63).
'LJLWDOVLJQDO it is possible to display the status of several units. To do this, use the + /
- buttons to select the address of the relevant unit. This then makes it possible to read
the display.
$QDORJXHVLJQDOthe address is not displayed, only the status of the connected unit.
3RVVLEOH
GLVSOD\V
([DPSOH
D8QLWDGGUHVVGLVSOD\LQWKHSUHVHQFHRIDGLJLWDOVLJQDO
E8QLWLGHQWLILFDWLRQVHHOLVW
F6HOHFWHGSURJUDPPLQJOLQH
'LVSOD\ 8QLW
0..15 / 0...255 Address / Unit identification
GLVSOD\ 6WDWXV
0 0 0 Telephone switch active / short-circuit
- - - No communication
55 Analogue room unit QAA 95
82 Digital room unit QAA 50
83 Digital room unit QAA 70
102 BMU hot water tank management unit
b)
c)
a)
2372Z06
)LJ
6SHFLDO
GLVSOD\V
- - - Sensor cut-off or no sensor connected
0 0 0 Sensor short-circuit

geminox THR 10-100 Series Specifications

General

Brand	geminox
Model	THR 10-100 Series
Category	Boiler
Language	English