BCB_N Rev.04 pag. 64
The buttons on the control panel are as follows:
With the machine OFF (0) press once to go to STANDBY (1). With
the machine on STANDBY press once to START a cycle. When a
cycle is in progress press once to STOP it. In whatever situation
the machine is, if the button is held down for 3 seconds the circuit
board is cut OFF.
Used to increase or decrease the value shown on the display.
With the machine on STANDBY and/or during the storage, press
once to start a defrost cycle.
With the machine on STANDBY press once to select a time
controlled chilling cycle.
Keep held down the button for 3 second in order to start the
continuous cycle
With the cycle selected, press once in order to select HARD or
SOFT process.
With the machine on STANDBY press once to select a time
controlled freezing cycle.
Press this button in order to use the accessory, as UV lamp,
warmed probe, where installed.
The icons on the control panel display are:
Illuminated when the machine is OFF; not illuminated in all other
situations.
Can be illuminated in red or green to indicate the temperature
measuring unit.
Flash when the cycles they refer to are in progress; remain
illuminated during the following holding cycle.
Illuminated during a temperature controlled cycle
Illuminated during a time controlled cycle.
Illuminated or flashing during the holding period.
Illuminated or flashing during the pre-cooling phase, also
CONTINUOUS CYCLE.
To Next Page
Loading...
