Need help?Do you have a question about the GemOro AuRACLE and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Technology | Electronic Conductivity |
| Type | Gold Tester |
| Material Tested | Gold |
| Karat Range | 6K to 24K |
Turn on the ANALYZER using the POWER/CALIBRATION button. The LED display shows 'Ready'.
Wipe pen probe tip, press POWER/CALIBRATION, touch 18K sample, wait for 'Done'.
File small area, place on plate, touch probe to filed area until LED settles on karat value.
Press and hold POWER/CALIBRATION to turn off. Hold button to check battery level.
Details on working voltage, stabilization time, and ideal environmental conditions.
Disassembling the ANALYZER, except for the battery compartment, voids the warranty.
Scan the QR code to watch the instructional video for guidance.
Compare karat stamp with test results; suspect if different. Interpret low range results (below 10K).
Pieces testing as NA are confirmed to be not gold.
Consider metal weight; light items may be costume jewelry or plated, suspect if too light.
Analyze yellow gold color; overly yellow or tarnished items may be fake or plated.
Examine clasp type; spring rings may indicate costume jewelry, avoid testing clasp only.
Always calibrate before use; recalibrate as needed. Periodically clean pen probe tip for consistent results.
Pen probe chemistry changes; clean tip and recalibrate periodically to maintain accuracy.
If calibration fails, check pen probe for wear or dirt; replace if it causes erratic readings.
Wipe off filings from pen probe tip and testing plate to prevent contamination and ensure accurate results.
File all metal before testing to expose base metal; clean file to avoid cross-contamination.
Indicates pen probe is not fully plugged in or material is non-conductive.
Suggests out-of-calibration device or presence of silver, palladium, or rhodium.
File tungsten/stainless steel to test as NA. Rhodium may test as platinum or higher karat.
Pure palladium tests between 18K and 24K; palladium in white gold raises karat readings.
High nickel may test lower karat; high silver may test slightly higher karat.
One-year limited warranty on ANALYZER, 30-day on pen probe. Excludes misuse.
Purchaser covers return postage. Repairs shipped FOB Destination within US, FOB Factory outside US.
To Next Page
