Need help?Do you have a question about the Gemtek WLTGG-122 and is the answer not in the manual?
General| Standards | IEEE 802.11b/g |
|---|---|
| Frequency Band | 2.4 GHz |
| Interface | Ethernet |
| Data Rate | 1, 2, 5.5, 11, 6, 9, 12, 18, 24, 36, 48, 54 Mbps |
| Security | WPA/WPA2 |
| Ethernet Ports | 1 |
| Power Supply | 12V DC |
Port for connecting the PoE adaptor via an Ethernet cable.
Location for SIM card insertion and the internal LED indicator.
Optional port for GPS antenna connection, depending on customization.
Screw on the rear panel for grounding the unit.
Indicates device power status and Ethernet connection activity.
Shows the status of the SIM card detection and connection.
Visualizes the quality of the LTE signal strength.
Guidelines for optimal placement to ensure best link quality.
Instructions for mounting the unit to a pole using the unadjustable angle clamp.
Instructions for mounting the unit to a pole using the adjustable angle clamp.
Connect grounding cable and prepare outdoor shielded Ethernet cable.
Guide for inserting and securing the RJ-45 cable into the ODU sealing gland.
Connect the PoE adaptor to the ODU and the network for power and data.
Steps to launch the web browser and navigate to the ODU CPE IP address.
Enter administrator credentials to access and configure device settings.
Details on equipment compliance with FCC Part 15 interference limits.
Prohibits unauthorized modifications and requires acceptance of interference.
Ensures compliance with FCC radiation exposure limits; maintain minimum distance.
Requirements for qualified installers, optimal placement, and approved antennas.
Important warnings regarding output power limits and regulatory compliance.
To Next Page