11
ACTIVE CARBON COLLECTOR
Besides particles, the Genano unit also remove gases with a high-surface-area
active carbon collector. The replacement frequency of the collector depends
on the usage conditions and concentration of gaseous impurities in the air. The
collector is recommended to be changed at least every 6 months.
POWER WASH
Power wash can be used if the unit is under heavy duty use in a location where
the air has a particularly large amount of particles.
It is recommended that the power wash be performed every 6 months even when
the unit is not used in an especially demanding environment.
Empty the flush bowl and fill the washing liquid container before performing the
power wash.
After the power wash, check the cleanness of the rinsing liquid. If necessary, you
can repeat the power wash.
The power wash is performed by pressing the POWER WASH switch (see H on
page 8) and holding it down until the fan stops and the unit starts the wash cycle
(about 5 seconds). The unit continues purifying air automatically after the wash. If
the power wash is done several times the unit needs more time to dry and start
automatically.
The change of the active carbon collector as well as other service measurements
are included in the service agreement. Units that have a service agreement are
in Genano’s service register and the service personnel will arrive for the yearly
service without a separate call.
WARNING! Do not operate the Genano 5200 unit without the active carbon
collector!
NOTE! The active carbon collector is to be changed twice a year.
Replacement of the active carbon collector can only be performed by service
personnel authorised by Genano Ltd.
To Next Page
Loading...