9
Operation of the device
NORMAL OPERATION
The unit is functioning and purifying air when the green OK light (A) is illuminated.
The unit efficiently collects atmospheric particles on the collection surfaces inside
the unit. Washing of the collection surfaces takes place automatically once a
week. During the flushing of the collection surface the green WASH light (B) is on.
NOTE! The green WASH light (B) is on until the drying period has ended.
After the washing cycle the unit is drying. During the drying the unit is silent and
the green WASH light (B) is on. Do not open the door when the unit is washing or
drying.
The washing cycle lasts less than a minute and the drying period can vary from
minutes up to 8 hours. The unit continues operation automatically when the
drying period is over.
NOTE! It is recommended to let the unit be continuously ON to ensure the best
possible air quality.
NOTE! The unit needs to be ON when adding washing liquid. Do not turn it OFF.
RUNNING OUT OF WASHING LIQUID
If the container has run out of washing liquid, the unit is unable to perform the
automatic washing function. When this happens the yellow ADD WASHING
LIQUID light (E) turns on.
The unit will continue its normal operation even if one automatic wash cycle is
missed due to a lack of washing liquid.
If washing liquid is not added within a week, the unit stops and the red SERVICE
light (D) lights up.
Add more washing liquid according to instructions given on page 7. Do not switch
OFF the unit.
To Next Page
Loading...